Compact chimney bend
The renovation solution for very narrow shafts. Simple and time-saving installation due to the two-piece design of the bend: an 87˚ bend Ø 80 with corresponding connection pipe L 250 mm.
The compact chimney bend offers a simple solution for a quick and easy renovation of narrow shafts or existing flue pipes in chimneys.
One of the most compact chimney bends available – fits into a 120 mm duct.
The compact chimney bend offers a simple solution for a quick and easy renovation of narrow shafts or existing flue pipes in chimneys. Applicable for inside dimensions as little as 120 mm. The outer dimension of the bend is only 118 mm. This makes it possible to lower the bend - pre-attached to the flue gas pipe - from the chimney from the top. As this method requires very little installation space, it is not necessary to make a large hole in the wall of the boiler room.
Bayonet joint
Once the compact elbow is in place, the horizontal connecting pipe can be connected from the boiler room. As standard, the bend is equipped with a protective cap to protect the seal and bayonet joint from damage and dirt during installation. When the bend is mounted on the support, this cap should be removed. Then the flue pipe can be connected with the bayonet joint of the bend and is ready for further installation.
Advantages
- Available in both flexible as rigid PP.
- Small external dimension of 118 mm.
- For chimneys and flue pipes with an minimum inner diameter of 120 mm.
- Bend can be inserted into the flue pipe from the top of the shaft.
- No need to cut a large hole in the boiler room wall.
- Secure connection due to bayonet connection.
- Double-lipped EPDM seal.
Chimney bend support
The compact chimney bend is available with a galvanised steel chimney bend support for use in architectural shafts or a compact stainless steel chimney bend support for the renovation of metal ducts.
Specifications
- Made of Polypropylene.
- Temperature resistant up to 120°C.
- Available in diameter (mm) 80.
- System approval 5000 Pa (class H1).
- CE marked according to the European standard EN 14471:2013.
